이벤트 배너
페이스북유튜브

전체 카테고리

카테고리 전체보기

사이드 카테고리


추천 메뉴


607-RSC (세라믹 엔진 베어링) 7x19x6 Front Ceramic Rubber

607-RSC (세라믹 엔진 베어링) 7x19x6 Front Ceramic Rubber

공유
SNS 공유하기
  • 페이스북 공유
    페이스북
  • 트위터 공유
    트위터
  • 핀터레스트 공유
    핀터레스트
  • 카카오스토리 공유
    카카오스토리
  • 자체상품코드
    607-RSC
  • 브랜드
    [ AVID ]
  • 할인

    마일리지

    할인 :

  • 판매가
    19,000
  • 수량
  • 판매금액 19,000원

 

 

Product Overview

The Avid 7x19x6 Ceramic Front Engine Bearing offers the maximum performance and reliability to almost all .21/.28 racing engines on the market at an unbeatable price. The bearing specs are Abec5, 7 G3 Si3N4 Ceramic Balls, PA66 with 30 Glass Fiber Cage, Chrome Steel 52100 Rings, and two rubber seals. A ceramic engine bearing can allow most RC engines to spin an extra 500 rpm with less drag and the life of the bearing is far greater over a steel bearing. Another benefit to ceramics is the weight difference in the balls allowing for less rotating mass (0.8g lighter then the steel ball version of this bearing).

Engines Used In

  • Almost all .21/.28 engines

Tips

  • Diagnosing: Typically you can tell a front bearing is going out if after a run there is a large wet spot on the bottom of your motor next to the flywheel. A little bit of wet is ok and usually just a sign of a rich low-end needle. If the bearing is bad your signs will be inconsistant tune and possible chance of damaging the crank/case if it completely goes.
  • Installation: The best way to install is to use a bearing puller/installer, OFNA makes a very affordable one. If you place the new bearing in the freezer for 15 minutes it will be easier to install.
  • Positioning: This bearing has a rubber seal on each side. There is a lot of debate on leaving both seals on the bearing or taking one off and installing the bearing with the rubber seal facing the outside world. Contray to popular belief, the seal is not designed to keep fuel from coming out of the engine. The seal is ONLY there to keep dirt from coming into the bearing. Personally I pop out one seal with an X-acto just to increase the performance of the bearing even further. However there is a large following for leaving both of them on. You will be amazed how freely this bearing spins even with both seals on so the choice is up to you.
  • Break In: For the first run of these bearings, Avid suggests that you fatten your motor up on the high-end needle so the ceramic balls will seat instead of skidding them.

 

Bearing Dimensions


배송안내

- 배송비 : 기본배송료는 3,000원 입니다. (도서,산간,오지 일부지역은 배송비가 추가될 수 있습니다)  70,000원 이상 구매시 무료배송입니다.

- 본 상품의 평균 배송일은 1~3일입니다.(결제 확인 후) [배송예정일은 주문시점(주문순서)에 따른 유동성이 발생하므로 평균 배송일과는 차이가 발생할 수 있습니다.]

 (단, 연휴 및 공휴일 제외 기준이며 택배사 사정에 따라 지연될 수 있는점 양해부탁드립니다.)

교환 및 반품안내

- 상품수령 후 7일 이내에 반품 및 A/S가 가능하며 상품 택(tag)제거 또는 개봉으로 상품 가치 훼손 시에는 상품수령 후 7일 이내라도 교환 및 반품이 불가능합니다.

 (상품의 하자 및 주문내역과 다른상품이 배송된경우 교환 및 반품 배송요금은 판매자가 부담합니다)

- 고객의 단순 변심으로 인한 반품 및 교환시에는 구매자에게 배송료가 청구됩니다.

 (구매시 무료배송이었던 경우는 왕복 택배비가 부과됩니다)

- 일부 상품은 신모델 출시, 부품가격 변동 등 제조사 사정으로 가격이 변동될 수 있습니다.

 

 

 

환불안내

- 상품 청약철회 가능기간은 상품 수령일로 부터 7일 이내 입니다.

AS안내

- 소비자분쟁해결 기준(공정거래위원회 고시)에 따라 피해를 보상받을 수 있습니다.

- A/S는 판매자에게 문의하시기 바랍니다.

이미지 확대보기

607-RSC (세라믹 엔진 베어링) 7x19x6 Front Ceramic Rubber

607-RSC (세라믹 엔진 베어링) 7x19x6 Front Ceramic Rubber
607-RSC (세라믹 엔진 베어링) 7x19x6 Front Ceramic Rubber

비밀번호 인증

글 작성시 설정한 비밀번호를 입력해 주세요.

확인

장바구니 담기

상품이 장바구니에 담겼습니다.
바로 확인하시겠습니까?

찜 리스트 담기

상품이 찜 리스트에 담겼습니다.
바로 확인하시겠습니까?

광고
네이버톡톡
카카오톡상담
최근본상품
0/0
상단으로 이동